Keep the ignition on for at least six seconds. Remove the newly programmed coded key. If the new integrated keyhead transmitter key has been successfully programmed, it will start the vehicle's engine and operate the Remote Keyless Entry System. If programming was not successful, wait 10 seconds and repeat Steps 1 through 9. HayaiKuruma. 1) Remove the grommet from the rear of the door. 2) Loosen, but do not remove the exterior door handle bezel retaining screw and remove the exterior door handle bezel. 3) NOTE: Pull the exterior door handle outward and to the rear to release it from the exterior door handle reinforcement. 1777 E Commercial Ave Lowell, IN 46356 Sales: 866-297-1489 Service: 866-297-1489 Welcome to Smith Ford of Lowell! Search our blogs for interesting tips, tricks and facts. My keyless entry keypad stopped working recently. The FOBs work, but the keypad doesn''t take any input or light up. This is not a code reset issue. I immediately thought "blown fuse" but frankly can''t determine which fuse would correspond. 2005 Ford Expedition Eddie Bauer. Step 8: Cut First Slot. We are going to cut a slot to insert the cotter pin. The cotter pin will be the new key ring loop OPPOSITE where the original ring loop was. Replace grinding wheel with cutting wheel. Align pin where you will cut slot OPPOSITE of original ring loop. Use cutting wheel to cut a 1/8 inch deep slot. Turn the key and NOTHING happens with the starter. The display reads "Key Not Detected". Turn the key around, use the other key, wiggle the key in the ignition nothing. Thirty minutes later car works great! Works great with both keys. So now it is working great. Seems weird to take it to the dealer. PEoPCbL.

ford fiesta keyless entry not working